Rockwell Automation 284E ArmorStart EtherNet IP Communications and Control Programming Manual - Manual (Page 41)

Rockwell Automation Publication 280E-PM001A-EN-P – August 2011 41
ArmorStart ® EtherNet/IP ™ Communications & Control Programming Manual Chapter 4
10. Attempt to enter a parameter value that is outside the allowed range by
setting parameter 106 to 1.50. The following warning screen should
appear. Click OK to clear this screen and return to the Parameters menu to
set the parameter within the allowed range.
11. Click OK at the bottom of the Properties menu to exit the menu.
Hand/Off/Auto (HOA)
Control This section focuses on controlling the ArmorStart EtherNet/IP unit using the
Hand/Off/Auto (HOA) keypad. The HOA keypad allows the user to switch
from Auto control mode, where the unit is controlled via the EtherNet/IP
communications, to Hand control mode, where the unit is controlled locally by
the user. Depending on the bulletin number of the product, the HOA allows the
user to run the motor forward (Bulletins 280E and 284E), stop the motor
(Bulletins 280E and 284E), run the motor in reverse (Bulletin 284E), and jog the
motor both forward and reverse (Bulletin 284E).
1. The figure below shows the Hand/Off/Auto keypad for the ArmorStart
Bulletin 280E.