Barco ID LR-6 R9010342 - Manual (Page 103)

6. Advanced
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Status bar position
5. Press ENTER
6. Use ↑ or ↓ to position the status bar
6.9.7 Sliderbox position
What can be done ?
The sliderbox can be displayed anywhere on the screen, the position can be set in this menu.
How to reposition the sliderbox?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Sliderbox position
5. Press ENTER
A sliderbox is displayed. Use the 4 arrow keys to drag the box to the desired position.
Image 6-110
There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch
between the two.
6.9.8 AutoImage Setup
What can be done ?
Autoimage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the LCD panels.
Autoimage can adapt the image based on following data :
• Total pixels per line
• Start pixel
• Phase
• Contrast/brightness levels
Autoimage works only for data signals.
How to set up AutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select AutoImage setup
5. Press ENTER
R59770134 ID LR-6 27/05/2011 99