Lenze EMF2178IB - Manual (Page 9)

About this documentation
Terminology used
1
l
9 EDSMF2178IB EN 3.0
1.3 Terminology used
Term Meaning
Standard device Lenze controllers that can be used with the communication module.
^ 13
Drive
»Global Drive Control« /
»GDC« PC software from Lenze which supports you in "engineering" (parameter setting,
diagnosing, and configuring) during the entire life cycle, i.e. from planning to
maintenance of the commissioned machine.
Code Parameter which serves to parameterise and monitor the controller. In normal speech,
the term is usually called "Index".
Subcode If a code contains more than one parameter, these parameters are stored in
"subcodes".
In this documentation a slash "/" is used as a separator between code and subcode
(e.g. "C00118/3").
In normal speech, the term is also called "Subindex".
Lenze setting These are settings the device is preconfigured with ex works.
Basic setting
HW Hardware
SW Software
PDO Process data object
SDO Service data object