Lenze E84AYCET EtherCAT MCI module - Manual (Page 42)

6 Commissioning
6.5 Establishing an online connection with the »Engineer«
42
Lenze · E84AYCET communication module (EtherCAT) · Communication Manual · DMS 5.0 EN · 05/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to configure an online connection to a field device which is connected to the Lenze
Controller via EtherCAT:
1. Go to the Communication path dialog box and the Bus connection list field, and select the
entry "Gateway Controller -> EtherCAT" there.
2. Click Search/Enter....
The Gateway Controller -> Set up EtherCAT bus dialog box is shown:
3. Enter the IP address of the Controller.
By clicking the Ping button, you can carry out a simple test which verifies whether a device
can actually be reached via the IP address set
4. Click OK.
• The Enter IP address dialog box is closed.
• In the Communication path dialog box in the Device access path column, the
corresponding device access path is shown
(e.g. "IPC:172_31_207_254.ECAT.ecat1.dev1001.").