Leica Biosystems TP1020 - Manual (Page 65)

65 Leica TP1020
9. Operating the Instrument in the Automatic Processing Mode
9.5 Resuming a paused process
9.6 Stopping or terminating a process
• To reassume processing press PAUSE/CONT
again.
Pressing this key will lower the basket into the
station. Processing continues as programmed.
While a run is paused, the infiltration time count-
down in the actual station will also be interrupt-
ed. When processing is resumed, the remaining
infiltration time in the station will be carried out
without interruption. Thus, the end of run time of
a process will be postponed by the length of time
the process was paused.
The display reading will automatically be
updated, showing the new end of run time.
If there is an emergency, an automatic process-
ing cycle can be stopped immediately and - in a
subsequent step - entirely aborted.
• To stop a processing cycle in progress press
STOP.
The carousel up-and-down movement stops im-
mediately.
The display reads "STOP?".
With this the instrument is asking you whether
you really want to abort the processing cycle
currently in progress?
• To resume processing, press START.
Processing will continue as programmed.