Leica Biosystems TP1020 - Manual (Page 48)

48 Instructions for Use V 2.9 RevC, English – 12/2013
6. Programming the Instrument
6.2.7 Displaying total program duration Once a program is set up, total run time can be
displayed.
• Press CLOCK to display the total run time of
the program.
The total duration displayed here is 1 day, 0 hours
and 12 minutes.
• To quit the display indication, press CLOCK
again.
6.2.8 Leaving the programming mode To end programming you have to leave the
programming mode.
• Press PROG to quit programming.
While you are in the programming mode, you cannot start a program. Prior to starting a program,
you must quit the programming mode.
Warning! Use caution when handling solvents! Make sure the premises are adequately venti-
lated! Explosion hazard!
Always observe worker's protection rules and use adequate protective gear (gloves, laboratory
coats).
While operating the instrument, no liquid may enter in contact with any of the electrical con-
nections or the interior of the instrument.
To remove and reinstall the reagent containers and wax baths, the instrument can be rotated
thus ensuring easy access to all stations at any time.