Leica Biosystems TP1020 - Manual (Page 42)

42 Instructions for Use V 2.9 RevC, English – 12/2013
5. The User Interface
Programming mode buttons
These buttons are used to enter or alter param-
eters when programming.
ARROW LEFT / ARROW RIGHT buttons (cursor)
To move the cursor in the direction of the arrow
to the respectively next data entry position.
• When pressing one of the ARROW buttons, the
cursor jumps to the next data entry position in
the direction of the arrow.
• To switch lines press ARROW LEFT.
PLUS / MINUS buttons
To modify the parameter in the position where the
cursor is located.
• To increase the numerical value, press PLUS.
• To decrease the numerical value, press
MINUS.
• To change the number of baskets from 1 to 2,
press PLUS.
• To change the number of baskets from 2 to 1,
press MINUS.
• To change the station number press PLUS or
MINUS respectively.
• To switch on the vacuum function (types 2 and 4)
push PLUS.
• To deactivate the vacuum function (types 2 and 4),
press MINUS.
These buttons are equipped with a re-
peat function. If one of the ARROW is
pressed for a while, the cursor jumps
to the respectively next data entry
position. If one of the PLUS / MINUS
buttons is pressed for a while, the dis-
played numerical value is continuously
increased or decreased.
The Leica TP1020 is available with and
without a vacuum function.
For the variants without vacuum func-
tion, no "V" appears in the display. Of
course a vacuum function cannot be
activated with the "V" buttons in those
cases.