JUMO 706560 LOGOSCREEN es Operating Manual - Manual (Page 65)

65
3 Operation and visualization
Status
messages Status messages of the CompactFlash card menu are shown in a separate
window in the menu.
- If you use the D key to confirm a message, the CompactFlash menu is
automatically terminated.
- If you use the E key to confirm a message, only the message is deleted,
the CompactFlash menu continues to be active.
The following status messages are possible:
Status message Description
Action successfully
completed. Directly before removing the CompactFlash card
from the instrument, it is necessary to call up
Update CF card so that all measurement data up to
the time of removal are contained on the
CompactFlash card. The data not yet stored since
the last automatic saving are written.
Action canceled. This message is shown when accessing the
CompactFlash card has been canceled by activating
the
button.
No card in disk drive! Access to the CompactFlash card was attempted,
even though there is none in the instrument.
Not enough memory available
on card! The CompactFlash card is full. No more data are
written.
Remedy: Insert a blank CompactFlash card before
the measurement data memory of the recorder is
also full. If this is not done, measurement data will
be lost.
Card is write-protected! The inserted CompactFlash card cannot be written
to because it is write-protected.
Card is not
DOS-formatted! An error has occurred while writing to the
CompactFlash card, because it was wrongly
formatted or not formatted at all.
Remedy: Format the CompactFlash card.
General error! An error has occurred while writing to the
CompactFlash card. The CompactFlash card may
be faulty.
Remedy: Insert new (DOS-formatted) CompactFlash
card.
No config. data on
the CompactFlash card
found! You start the function CF card Î Config. data and
there are no configuration data on the
CompactFlash card.
Remedy: Check card on PC and generate data
again, if necessary.
No user list on
the CompactFlash card
found! You start the function CF card Î User list and there
is no user list on the CompactFlash card.
Remedy: Check card on PC and generate list again,
if necessary.