JUMO 706560 LOGOSCREEN es Operating Manual - Manual (Page 56)

3 Operation and visualization
56
Contrast The contrast of the screen can be set here. This ensures that the screen is
always highly legible, even under difficult light conditions.
Speed
indication Here, “time/div“ or “mm/h” can be selected for the speed display in the
vertical and horizontal diagrams.
Example: a diagram speed of 1h/div corresponds to 22mm/hr.
Memory
indication You can determine the appearance of a part of the status line here.
The following symbols can be set:
Memory indication ➔ CF card (external) = always
or
Memory indication ➔ CF card (external) = if inserted
If “CF card (external)” is not set to “always”, there is a further parameter:
Memory indication ➔ Internal memory: for = read-out via CF
or
Memory indication ➔ Internal memory: for = ser. read-out
v Chapter 2.2 “Operating principle and graphic elements”
Display off
(screen saving) Display off ➔ Switch-off event = waiting time
For screen saving, a time between 0 and 32767min can be set here. If no key
on the recorder is operated during this time, then the screen goes dark. If 0min
is set, then screen saving is deactivated.
Display off ➔ Switch-off event = control signal
Display switch-off is initiated by one of the digital signals. For additional
information on the digital signals, see
v Chapter 2.4 “Digital signals”
H
The power LED blinks during screen saving.