JUMO 706560 LOGOSCREEN es Operating Manual - Manual (Page 113)

113
5 Setup software
Ethernet
interface This function transmits an Ethernet configuration to a device. It does not
matter how the device is connected to the PC. Transmission via a serial
interface is also possible.
The Ethernet configuration is not controlled through the dialog window in the
setup software, but only here, in the Extras menu.
Write interface
texts This function can be used to transmit batch texts, recipes and a message text
to a device.
Batch texts are used to describe a batch report. The batch texts can only be
written, if the contents of the right column of a text has been configured as an
interface text.
Recipes are used to describe a batch. Recipes can only be entered through
the Extras menu, and then transmitted to a device. Recipe data are evaluated
by the PC Evaluation Software PCA3000.
The message text can be used to make an entry in the event list for a device.
The functions are independent of the latest setting in the dialog window. The
data can be transmitted to a device, without causing a new configuration.
A
If a device is already connected via an Ethernet link, then the
function can be used to alter the Ethernet configuration in the
device. The Ethernet data in the device list are now incorrect, i.e.
you must now edit the device setting in the device list.
H
In order to be able to write interface texts, rights exist on the de-
vice side, as well as on the PC side (special case).
The device right “Enter batch texts” is available in the device as a
factory default right.
But since not every user is allowed to enter batch texts, the addi-
tional right "Write interface texts” has been introduced on the PC
side, thereby increasing security.
The message text for the event list also incorporates a right on the
device side (“Write Teleservice (comments...)”).
Accordingly, it is not enough to allocate the setup right only.