HYDAC CMU 1000 - Manual (Page 69)

Condition Monitoring Unit CMU 1000 Page 69
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
With "Perform cycle", you can start the simulation for a single processing
cycle and then view the thereby resulting status modifications of the actions
afterwards.
With "Start autom. cycle“, you start a permanent, continuous program
simulation. You can change the input values during the simulation any way
you like and observe the status modifications of the actions.
Mit "End autom. cycle“, you stop the permanent, continuous program
simulation.
Pressing "Close“ takes you back to the CM Editor.
During the simulation, the assigned input values and action statuses are also
displayed in the Linked Functions window at the corresponding symbols.