HYDAC CMU 1000 - Manual (Page 28)

Condition Monitoring Unit CMU 1000 Page 28
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
• Pressing "Disconnect" in the Device field allows you to interrupt the existing
connection between the CMU 1000 and the PC.
• The interface (COM port) used can be closed again on the PC by pressing
"Close" in the Interface field.
• At the end you also have the option of selecting an automatic connection setup.
Placing a checkmark in the box for "Set up connection automatically next
time " causes the CMWIN software to set up a connection automatically with
the CMU 1000 that is linked via USB during startup. To ensure that this
happens, no changes should be made to the interface parameter settings after
the currently existing connection is disconnected.
• Click on "OK" to complete the connection setup and to
return to the CM Manager.
• The following window opens after the connection has been successfully
established:
The menu structure and window properties of the CM Manager are explained below in
greater detail in Chapter 5.2.5 ff.