HYDAC CMU 1000 - Manual (Page 35)

Condition Monitoring Unit CMU 1000 Page 35
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
• Select Change in the Bus address line. The following window opens:
• Select the respective device address in the selection window
(Address d in our example).
• Confirm this with OK.
• Afterwards click on Connect to connect the PC to the Slave CMU (Address d).
• The successful establishment of the connection will be signalled as shown
below:
• End the connection setup by confirming with OK.