HYDAC CMU 1000 - Manual (Page 43)

Condition Monitoring Unit CMU 1000 Page 43
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
• You can set up a list of telephone numbers (address book) with Telephone list.
• Click on “OK“ to apply the entries or “Cancel“ to discard these changes. In
either case you will then return to the Connection window.
• Click on Open to open the selected interface. The opened interface is indicated
by a green dot on the upper right.
• Click on "Change" to open the window for the pass-through mode.
• Select the HSI address of the CMU 1000 connected to the CSI-F-10 in the
selection window (Address a in our example).
• Afterwards, click on Switch on in order to switch on the pass-through mode for
the selected channel.