HYDAC CMU 1000 - Manual (Page 20)

Condition Monitoring Unit CMU 1000 Page 20
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
4.2 Control Element on the Device
The following control element is available on the device for operating the CMU 1000
and performing the basic settings:
Keypad
LCD display
4.3 Power Supply Connection
Before installing or removing an electrical device, you must make sure that the voltage
supply to the devices is switched off. Implement all of the necessary safety precautions
and make sure that the voltage supply to the CMU 1000 is switched off before
installation/removal.
Warning!
If you attempt to install or to wire the CMU 1000 and/or connected accessory
components while it or they are switched on, this could lead to an electrical shock
and/or to device malfunction. Implement all of the necessary safety precautions and
make sure that the voltage supply to the CMU 1000 and/or to connected accessory
components is switched off prior to installation/removal.
+ -
18 .. 35 V DC