EUCHNER AS-i Safety Monitor for 2 AS-i circuits - Manual (Page 80)

80 Subject to reasonable modifications due to technical advances Id.-No.: 103336 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i Safety Monitor for 2 AS-i circuits
Diagnostics for AS-i Monitor and networking using AS-i Master
11. Diagnostics for AS-i Monitor and networking using AS-i Master
11.1 Introduction
The new AS-i Safety Monitor – in conjunction with Euchner GmbH + Co. KG AS-i
Masters – offers not only superior on-location operation and diagnostics, but also
makes this also accessible over the network.
11.2 On-location operation
The Monitor display shows all the diagnostics data directly in the same manner as
on the Gateway with integrated monitor.
For characteristics which apply to both the 1
st
and 2
nd
AS-i circuit, the circuit is
selected with this selection box:
11.3 Spontaneous messages
The strategy for spontaneous display of messages for Euchner GmbH + Co. KG
AS-i masters is:
• When the AS-i network is functioning error-free, a smiley is displayed.
• When there is a fault on an AS-i slave, this is displayed until the fault is no
longer present.
• For the Safety Monitor the desire is to keep the concept as similar as possi-
ble, since it is so familiar to and accepted by customers.
• When there are no faults present, the states of the safety unit are displayed
as a text beneath the smiley.
• When two local release circuits are present, a line is displayed with their sta-
tus, or two lines for 4 local circuits.
Information!
The menu is described on the separate menu page.
AS-I CIRCUIT 1
AS-I CIRCUIT 2
☺Press OK for Menu
Output Circuit
1:ON 2:ON
3:ON 4:ON