EUCHNER AS-i Safety Monitor for 2 AS-i circuits - Manual (Page 56)

56 Subject to reasonable modifications due to technical advances Id.-No.: 103336 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i Safety Monitor for 2 AS-i circuits
Operation in advanced display mode
• Confirm with OK (display flashes)
• Use the arrow keys to enter the desired address
• Confirm with OK (display stops flashing)
• Use one of the two arrow keys to exit the input screen
• Save with OK, or cancel the process by pressing ESC.
The teaching procedure was successful if an OK appears in the third line.
The following error messages are possible:
Press the OK key to save the learned code table or press ESC to discard it.
9.3.1.3 COUPLING SLAVE
Main Menu || AS-I SAFETY || TEACH CODES || COUPLING SLAVE ||
This menu point allows you to teach the code table for a coupling slave. To con-
tinue, enter the PIN and confirm with OK.
In the following menu you select the AS-i circuit.
After selecting the AS-i circuit the safe unit switches to configuration mode.
Then enter the slave address.
Information!
Be sure that all slave contacts on the corresponding slave are closed.
Message Description
RR Both contacts open
RX Left contact open, right contact closed.
XR Right contact open, left contact closed.
TEACH CODES
ENTER PIN
0000
OK
AS-I CIRCUIT 1
AS-i CIRCUIT 2
COUPLING SLAVE
SLAVE ADDR.
––1
ESC