EUCHNER AS-i Safety Monitor for 2 AS-i circuits - Manual (Page 66)

66 Subject to reasonable modifications due to technical advances Id.-No.: 103336 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i Safety Monitor for 2 AS-i circuits
Operation in advanced display mode
Using this menu you can delete the safe configuration from a chip card bank. This
procedure is PIN protected.
9.3.8 PROTECT (protect safe configuration)
Main Menu|| AS-I SAFETY || PROTECT ||
This function allows you to protect the safe configuration before downloading
over the serial interface.
9.4 DIAGNOSTICS
Main Menu || DIAGNOSIS ||
This menu contains the following sub-menus:
STOP MONITOR
OK
START MONITOR
OK
PROTECT
ENTER PIN
0000
OK
SAFETY SLAVES
MONITOR
ERROR COUNTERS
LPF
FAULT DETECTOR
AS-I MONITOR
SAFETY SLAVES: Safety input slaves
MONITOR: Display the diagnosis data for the Safety Monitor
ERROR
COUNTERS:
Fault counter for each single AS-i slave