EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 57)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Function and startup of the Safety Monitor
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 57
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
• After entering the PIN, the display can be used to start a teaching procedure
for the code sequences. The monitor stops immediately after entering the
PIN. After teaching, the monitor starts after a prompt and acknowledgement
on the display.
Legend: "
3
" = possible; "–" = not possible
Code sequences for releasing a configuration do not necessarily have to have
been successfully learned. It is also possible to release without code sequences,
which must then be learned at a later time. An AS-i Gateway with integrated AS-i
Safety Monitor does not go into the protecting operating mode without learned
code sequences.
Teaching the code sequences is simple to perform:
• Using the ESC/Service key (See section figured AS-i slave>)
or
• Using the display (See section ).
8.5.2 Function of the ESC/Service key
In traditional (classical) display mode, the ESC/Service key takes on two kinds of
functions:
• Briefly pressing the ESC/Service key unlocks the Safety Monitor when red is
flashing
• A longer press (3s) starts the teach procedure for a slave.
Action ASIMON Software On AS-i Safety Monitor
Configure and load into Safety
Monitor
3
3
(only from chip card)
Stopping 3 3
Releasing 3 –
Starting
3 3
Teaching code sequences 3 3
Changing the password 3 3
(only from chip card)
Changing the PIN –
3
Information!
For additional information see section slave>.