EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 158)

158 Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Appendix: Example for startup on a Siemens S7
17.2.4.1 General DP parameters
Startup when nominal configuration is not the same as actual configuration:
Use this parameter to specify whether the AS-i circuit should be started up even if
the AS-i circuit has a different configuration than the stored AS-i configuration.
17.2.4.2 Device-specific parameters
Acyclic Communication
Turning acyclic PROFIBUS DP communication on/off according to the DPV1
standard.
Default: Communication turned on according to DPV1.
AS-i Flags
Specifies whether the AS-i flags are sent in the PROFIBUS diagnostic.
Default: Transmission in the PROFIBUS diagnostic data.
List of Configuration Errors
The AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor saves a list of
all AS-i slaves which have triggered a present configuration error. This list can be
sent with the PROFIBUS diagnostic data.