EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 112)

112 Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Operation in advanced display mod
9.9.7.2 CONTROL RUN (start or stop the control program)
Main menu || SETUP || AS-I CONTROL || CONTROL RUN ||
This function is used to start or stop the control program. It modifies the START
BIT in the Control Info menu.
9.9.7.3 CONTROL FLAGS (control program flag memory)
Main menu || SETUP || AS-I CONTROL || CONTROL FLAGS ||
This function is used to read and modify the control program's flag memory.
• First, a row needs to be selected using the soft keys.
• Pressing OK displays the selected row.
After pressing OK, the display mode changes and it is now possible to select indi-
vidual flags using the soft keys. The selected flag is then displayed in binary for-
mat at the top row.
• Pressing OK again enables editing the selected binary value.
CONTROL RUN
RUN
CHANGE
RUN: The control program has been started. The control program
can be stopped even if the start bit is set, for example if a con-
figuration error occurred or if the master is in configuration
mode.
STOP: The control program has been stopped.
CHANGE: Change the state between RUN and and STOP.
CONTROL FLAGS
0:2A 47 2B 2C
4:83 BD F2 58
...
124: 4A C3 84 7A
5:10111101
4:83 [BD] F2 58