EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 145)

AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Accessories
Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG 145
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
16. Accessories
16.1 AS-i Safety at Work
16.1.1 AS-i Safety Monitor Generation II
The AS-i Safety Monitor in Stainless Steel is an emergency stop control device. It
monitors the assigned safety-related AS-i sensors by the configuration software
ASIMON 3 G2. In case an emergency stop should be required or if a fault occurs,
the AS-i safety monitor in its protective mode can switch off the system within a
response time of 40 ms at most.
The safety monitor in the second generation offers a stainless steel housing with
a LCD display for indication of slave addresses and error messages. The configu-
ration data are stored in the integral EEPROM and they can be overwritten by
data stored on the chip card and vice versa.
The AS-i Safety Monitor enables the use of sensor-controlled safety components
according to EN 954-1 up to category 4/SIL 3.
Usage of extensive logic components and formation of AS-i groups is possible,
too.