EUCHNER AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor for 2 AS-i circuits - Manual (Page 146)

146 Subject to reasonable modifications due to technical advances Id.-No.: 103329 Issue date - 24.10.2008 EUCHNER GmbH + Co. KG
Kohlhammerstraße 16 • D-70771 Leinfelden-Echterdingen Tel. +49/711/75 97-0 • Fax. +49/711/753316
AS-i 3.0 PROFIBUS Gateway with integrated Safety Monitor
Appendix: Example for startup on a Siemens S7
17. Appendix: Example for startup on a Siemens S7
This example shows you how to start up the AS-i 3.0 PROFIBUS Gateway with
integrated Safety Monitor GMO-PR-1D-C02 on a Siemens S7-300 programmable
logic controller.
17.1 Hardware configuration
17.1.1 Electrical connection for AS-i
To supply the AS-i circuit, connect the output on the AS-i Power Extender or an
AS-i power supply to the AS-i 3.0 PROFIBUS Gateway with integrated Safety
Monitor. Observe correct polarity of the terminals AS-i(+) and AS-i(-).
In the following the desired AS-i slaves are connected to the AS-i circuit. The AS-
i slaves have their device address set to 0 by default. This must be changed to
the desired AS-i slave address.
Information!
This example shows the start up of the AS-i 3.0 PROFIBUS Gateway with integrated
Safety Monitor GMO-PR-1D-C02
a Siemens S7-300 programmable logic control-
ler. The start up is the same with new range of devices.
Hardware used:
SIMATIC S7 power supply PS 307 5A
SIMATIC S7-CPU with PROFIBUS DP CPU 315-2DP
Order No.: 6ES7 315-2AF03-0AB0
Firmware Version 1.2
AS-i 3.0 PROFIBUS Gateway with inte-
grated Safety Monitor GMO-PR-1D-C02
Id.-No. 099585
AS-i-Power-Extender
AS-i-4i Module
AS-i-4I/4O Module
Power supply Powers the AS-i components through the
AS-i Power Extender
Software used:
GSD-File for the AS-i 3.0 PROFIBUS
Gateway with integrated Safety Monitor Id.-No. 102047
SIMATIC Step7 Version 5.2 Service
Pack 1 Version: K5.2.1.0
Associated documentation:
AS-i/PROFIBUS-Gateway Operating Manual
SIEMENS S7-300 documentation