R setup, See “quick color (vivid, Master/slave operation – ETC Desire Series v1.6.0 User Manual User Manual
Page 74: Master, N o t e
68
Desire Series v1.6.0 User Manual
Quick Color (Vivid, Lustr+, Fire and Ice, Studio HD)
Quick Color allows you to easily select a color and its intensity from a predefined menu.
This feature overrides any presets or sequences previously selected and is only available
when there is no external DMX signal to the fixture. For a list of available colors, see the
table on
.
To select a Quick Color:
Step 1:
Press the [
] to quickly access the Presets and Sequences screen.
Step 2:
Within the Presets and Sequences screen, scroll to Quick Color.
Step 3:
Press [
].
Figure-4.30 Selecting Quick Color on the Presets and Sequences Menu.
Step 4:
Scroll to Color and press [
].
Step 5:
Press [
] or [
] to select the desired color
Step 6:
Press [
] to commit the selection.
Step 7:
Scroll to Intensity and press [
].
Step 8:
Press and hold [
] or [
] to adjust the fixture’s intensity.
Step 9:
Press [
] to commit the selection.
•
To set the Intensity to 0, press the [
]. Pressing [
] a second time will
return the fixture to its previously set Intensity.
•
If power to the fixture is lost while in Quick Color mode, the fixture will return
to the Quick Color menu once power is restored.
Master/Slave Operation
When similar fixtures' DMX or data connections are linked together and there is no external
DMX signal going to them, one fixture automatically controls all other fixtures in the chain
when a Preset, Sequence, or Quick Color is initiated.
Master
Master is the one fixture that controls all fixtures in the daisy chain. By default, it is
whichever fixture had its Preset, Sequence, or Quick Color selected or adjusted most
recently. The Master fixture can only control Slave fixtures to produce identical output at the
same time as itself. The Master fixture cannot control Slave fixtures to operate individually
or to run chase-type or time-offset sequences.
Changes and edits to Presets or Sequences that are made to the Master fixture may be
copied to the internal memory of all Slave fixtures for later use when these fixtures are
disconnected from the data daisy chain.
When operating as the Master fixture, the fixture displays Master on its home screen.
N o t e :
Exiting the Quick Color menu will return the fixture to the state it was in before
entering the menu.
Presets and Sequences
Focus: Off
Presets
Sequences
Quick Color
Preset 1 is Active
No Sequence is Active
Quick Color
Intensity
:
100%
Color:
–––