ETC Desire Series v1.6.0 User Manual - Manual (Page 35)

2
Installation and User Interface Overview 29
D40, D60 Connections
Connect the AC cable:
Align and insert the power connector. Twist the connector clockwise until it locks into place.
Disconnect the AC cable:
Slide back the locking tab to unlock, twist the connector counterclockwise, and then pull and
disconnect the power connector.
Connect the DMX cable:
Align and insert the DMX connector.
Disconnect the DMX cable:
Press the release button on the connector or on the fixture and pull the connector out.
D40XT Connections
Connect the AC cable:
Align and insert the connector on the fixture's power cord to the mating connector on the
extension cord or adjacent fixture. Twist the enclosure rings together to form a tight seal.
Disconnect the AC cable:
Loosen the enclosure rings around the connectors until fully separated, and then pull apart
the two connectors.
Connect the DMX cable:
Align and connect the DMX connectors, pushing firmly until the locking tabs are fully
activated.
Disconnect the DMX cable:
Press the release button on the connectors and pull the connectors apart.
D22 Portable DMX/RDM Connections
Connect the DMX cable:
Align and connect the DMX connectors, pushing firmly until the locking tabs are fully
activated.
Disconnect the DMX cable:
Press the release button on the connectors and pull the connectors apart.