ETC Desire Series v1.6.0 User Manual - Manual (Page 11)

Introduction 5
Safety
The Desire series fixtures are intended for professional use only. Read entire User Manual
before using equipment.
W A R N I N G : Note the following safety warnings before use:
• Do not mount the Desire series fixture on or near a flammable surface.
• Use the D22, D40, and D60 fixtures in dry locations only, where humidity does not
exceed 90 percent (non-condensing). These fixtures are not intended for outdoor use.
(Only the D40XT is approved for outdoor use.)
• Mount and support the fixture only by the primary suspension holes in the yoke or floor
standing yoke.
• Suspend the fixture from a suitable structure using only the hardware rated for the
weight of the fixture.
• In addition to primary suspension, attach a safety cable (ETC Model 400SC or other
approved safety cable or device) to the fixture housing. Appropriate attachment point
(hole) is provided in the protruding tab on the fixture housing.
• Disconnect the unit from power and from DMX before all cleaning and maintenance.
• Maximum recommended ambient operating temperature: Ta=40°C (104°F)
• Maximum anticipated external surface temperature: Tmax=80°C (158°F)
• External temperature after 5 minutes of full-brightness operation and 23°C (74°F)
ambient: 38°C (100°F)
• External Temperature (steady state achieved) at 23°C (74°F): 70°C (158°F)