Aim adjustment, D40, d40xt, d60, d22 portable – ETC Desire Series v1.6.0 User Manual User Manual
Page 27
2
Installation and User Interface Overview
21
Aim Adjustment
D40, D40XT, D60, D22 Portable
The fixture can be tilted up and down and rotated (panned) to aim the light where it is
needed. The adjustment is the same for the yoke or floor stand. To assist aiming the fixture,
you can turn it on without having to be connected to DMX control or enabling a preset. For
more information, see
Figure-2.2 Tilting the Fixture on a Yoke.
Turning the Fixture On
Step 1:
Apply power to the fixture.
Step 2:
On the back of the fixture press [
].
Step 3:
With Focus selected, press [
].
Adjusting the Tilt
Step 1:
Loosen the yoke locking knob. Do not remove the knob.
Step 2:
Tilt it to the desired angle.
Step 3:
Tighten the yoke locking knob.
Adjusting the Pan
The pan is adjusted at the hanging clamp. Please consult the clamp manufacturer’s
documentation for instructions on loosening and rotating the yoke at the clamp.
W A R N I N G :
The safety cable (or other approved safety device) must be securely
attached to the safety cable loop before loosening the clamp.
Yoke locking knob