ETC Desire Series v1.6.0 User Manual - Manual (Page 60)

54 Desire Series v1.6.0 User Manual
LED Settings
Use the LED Settings menu to adjust fixture performance. From the LED Settings menu,
you can set the following.
• Output
• Curve
• Output Frequency
• Red Shift
• White Point
Figure-4.10 Selecting LED Settings on the Advanced Menu.
Output
Use Output to choose the optimal balance between two competing performance
parameters, maximum brightness and output consistency, by adjusting:
• How much the fixture limits the overall power to the LED array.
• How the fixture reduces output as internal fixture components heat up during use or in
high ambient temperatures.
The output options are as follows:
Regulated
Regulated is a moderately constrained power or brightness with consistent output under
typical use. Power to the LEDs is separately regulated in order to maintain consistent
brightness during the initial fixture warm-up period. This is recommended for most indoor
applications.
Protected
Protected provides the most consistent output possible with the greatest potential for
reduced overall brightness. This is best for outdoor use, changing environmental
temperatures, and applications with high requirements for consistency in extreme operating
conditions.
N o t e : Once any one of the seven individual color channels is altered from its neutral
starting position, the settings for the original color point may no longer reflect the
actual output of the fixture.
When using RGB, HSI, HSIC, or Studio profile for color selection, each fixture
makes accommodations for the specific LEDs in its array and produces output that
is consistent with other fixtures, whether or not they use LEDs from the same
production batch.
Operating with Plus Seven enabled can override this calibration, and multiple
fixtures may produce slightly different outputs when individual color channels are
altered from their neutral starting points.
LED Settings
Output : Regulated
Curve: Standard
Output Freq:
1200
Red Shift: Off
White Point: 3200K
Advanced Menu
DMX Settings
LED Settings
Presets and Sequences
Diagnostics
Local Settings
Copy All Settings