beautypg.com

Det-Tronics PIRECL Infrared Hydrocarbon Gas Detector PointWatch Eclipse User Manual

Page 40

background image

F-1

95-8526

14.2

Appendix F

hArt coMMUnicAtion

Digital communication with the Pointwatch Eclipse is necessary to monitor internal status and to modify the factory

settings. This appendix provides guidance on establishing HART communication, and describes the communication

menu structure when using the Eclipse with the HART Handheld Communicator.

estABlishinG locAl hArt coMMUnicAtion With pointWAtch eclipse
The HART Handheld Communicator can be connected to the 4-20 mA circuit as shown in the wiring diagrams provided

in the Installation section of this manual. If the Eclipse is equipped with an I.S. HART communication port on the side of

the detector, unscrew the protective cap and connect the HART Communicator test probes to the two terminals inside

the port (non-polarized).

Press the "on" key to switch on the HART Handheld Communicator. The Online menu is the first menu to appear when

the Communicator is properly connected to the Eclipse. This menu is structured to provide important information about

the connected device. The HART protocol incorporates a concept called the "Device Description Language" (DDL)

that enables HART instrument manufacturers to define and document their product in a consistent format. This format

is readable by handheld communicators, PC's and other process interface devices that support DDL.

NOTES

Proper analog signal output termination and minimum loop resistance must be completed in all cases to enable
HART communication. Failure to provide proper analog signal output loop resistance will preclude all HART
communication.

It is possible to establish HART Communication with the PIRECL in Generic HART communication mode. In
this mode, HART communication with the PIRECL detector will be established, but the Communicator will not
recognize the PIRECL as a gas detector. Generic HART communication will not provide access to the PIRECL
DDL menu and important set-up, diagnostics or operation functions, including gas type selection.

proceDUre to DeterMine iF eclipse DDl is present in YoUr coMMUnicAtor
1. From the Main menu, select the Offline menu.
2. From the Offline menu, select New Configurations to access the list of device descriptions programmed into your

HART Communicator. The Manufacturer menu displays a list of each manufacturer with available DDLs.

3. Select a manufacturer, and the display will show the list of available device types.
4. If you cannot find the Eclipse device on your Communicator, the specific DDL is not programmed into the Memory

Module. Your HART Communicator will require a DDL upgrade in order to access all Eclipse DDL functions.

The HART Communication Foundation (www.hartcomm.org) manages the HCF Approved DDL Library and programming

sites for HCF Approved field communicators. A complete listing of the DD Library is available for download and

provides manufacturer and device type file identification.