Baja Marine Outlaw 23 - Manual (Page 79)

9.3
23 Outlaw ®
S
eCtiOn
9 • C
are
& r
eFiniShing
R
Speed changes you. TM.
38°C); rnse thoroughly to remove soap. DO nOT UsE
DETERgEnTs. allow to completely dry.
Wash and clean vnyl wndows wth a warm soap
soluton. Use a soft cloth or sponge and do not scratch
the surface.
If you have stubborn cleanng cases, call your dealer
for proper procedures. Do not try your own cleanng
procedures as they may permanently damage the
canvas.
after each use, especally n salt water areas, rnse the
canvas completely wth fresh cold water. Then let the
canvas dry completely before stowng.
DO nOT, at anytme, dry any canvas part n a conventonal
dryer, because shrnkng may occur.
all metal components of the canvas should be rnsed wth
fresh cold water and exposed components wped dry to
mantan appearance and workng order.
8. e
xTerior
u
pholsTerY
f
abric
Exteror fabrcs should be cleaned wth a sponge or
very soft scrub brush and a mld soap and warm water
soluton. after scrubbng, rnse wth plenty of cold, clean
water and allow the fabrc to ar dry n a well ventlated
place, preferably away from drect sunlght.
Mldew can occur f your boat does not have adequate
ventlaton. heat alone wll not prevent mldew; you must
also provde for fresh ar crculaton.
REFER TO ThE OWnER’s ManUal PaCkET FOR
InsTRUCTIOns anD WaRRanTy InFORMaTIOn.
9. i
nTerior
u
pholsTerY
f
abric
Cleanng and mantenance nformaton provded by
the materal manufacturer, s n your Owner’s Manual
Packet.
REFER TO ThE OWnER’s ManUal PaCkET
FOR InsTRUCTIOns anD OThER ClEanIng
InFORMaTIOn.
Always clean spots, stains, etc., immediately.
Test an unseen area of fabric before cleaning stain,
to insure that cleaning material will not cause
damage.
NOTICE