Baja Marine Outlaw 23 - Manual (Page 41)

3.5 23 Outlaw ®
S
eCtiOn
3 • u
Sing
y
Our
B
Oat
R
Speed changes you. TM.
8. s
hifTinG To
D
rive The
b
oaT
Brng throttle lever all the way back. Once done,
the drve s ready to shft.
Move shft lever ether forward or reverse. Then
move throttle lever forward, the drve unt wll
engage and boat wll start to move slowly n ether
forward or reverse. Once clear of the dock, moorng,
people and/or the no-wake zone and the boat has
been shfted nto forward gear, move throttle lever
forward to desred engne speed.
WaRM EngInE - Move throttle lever about 1/4
open throttle poston. Do not pump lever.
FlOODED EngInE - Move throttle lever to full
open poston. DO nOT pump lever. When the
engne starts, move throttle lever back rapdly
to decrease engne speed to between 1000 and
1500 RPM.
8. TO sTaRT EngInE:
Turn gnton keys clockwse,
as you would an automoble
(Fg. 3.5.1).
9. after engne starts, reduce
speed to between 1000 and
1500 RPM and check ol
pressure.
10. If ol pressure s correct, let
engne warm up to normal
temperature range as specified
n the engne manual, before
shftng nto forward or reverse
gear (Fg. 3.5.2).
IF EngInE TEMPERaTURE
gOEs aBOVE nORMal
RangE. shUT DOWn ThE
EngInE IMMEDIaTEly. gET
TRaInED hElP TO FInD
anD FIX ThE PROBlEM
(Fg. 3.5.3).
IF OIl PREssURE gOEs aBOVE OR BElOW
OPERaTIng RangE, shUT EngInE DOWn
IMMEDIaTEly. gET TRaInED hElP TO FInD
anD FIX ThE PROBlEM.
(F
ig
. 3.5.1)
(F
ig
. 3.5.2)
(F
ig
. 3.5.3)
! CAUTION
Cockpit can fill with water if boat is moving
forward, when it is put into reverse.
Before shifting into reverse, shift to neutral, wait
for the boat to stop moving forward, then shift
into reverse.