Baja Marine Outlaw 23 - Manual (Page 69)

8.7 23 Outlaw ®
S
eCtiOn
8 • r
equired
i
nSpeCtiOn
, S
erviCe
, &
M
aintenanCe
R
Speed changes you. TM.
c. M
iscellaneous
• Check all thru-hull fittings for unobstructed water
passage. Be alert for any deterorated hoses
and/or fittings below the water line which might
fal n servce and admt water.
• Test the navgaton lghts.
• Check all wrng for loose connectons.
• Check all swtches and equpment for proper
operaton.
• Check blge blowers for proper operaton. Turn
on blowers and place hand over hull blower vent
to make sure ar s comng from vent.
• anchor lnes and gear should be nspected and
replaced f necessary.
• Make sure the hull dran plug s n place and
tght.
• Clean blge thoroughly f t was not done at
lay-up.
• Check all engine fluid levels.
• Check fuel lnes for damage and/or leaks. Make
sure that they do not come nto contact wth
movng parts.
• Check Carbon Monoxde detector to see f
operatonal
6. s
ecuriTY
c
onsiDeraTions
Be conscous of the securty of your boat. always
remove the keys from the gnton, lock hatches, lock
the cabn door, remove and stow any removable
electronc gear (fshfnders, lORan, etc.) and
personal gear (fishing poles, etc.) normally left
aboard your boat.
7. p
oWer
s
TeerinG
s
YsTeM
M
ainTenance
• lubrcate the control valve on the power
steering cylinder through the grease fitting with
multpurpose lubrcant untl grease appears
around the rubber boot.
• Coat power assst steerng output shaft and
exposed steerng cable end wth approprate
lubrcant.
• lubrcate cable end gude pvot pont wth saE
30W engne ol.
• Check power steering fluid level in the power
steerng pump reservor.
• Inspect all hydraulc hoses for leaks. keep hoses
from rubbng on movng parts and from contact
wth hot engne parts.
• Check all fittings, clamps and bolts for tightness
every month.
• Check power steerng pump drve belt for
wear and proper tenson every month. Do
not overtghten belt. Ths can cause bearng
falure.
REFER TO ThE EngInE OPERaTOR’s
ManUal FOR PROPER FlUID lEVEls anD
lUBRICanTs.
Baja ® Marne recommends that all repars and/or
replacements to steerng systems be made by
qualified dealers authorized by manufacturer of the
steerng system of your boat.
DETaIlED OPERaTIng InsTRUCTIOns anD
WaRRanTy InFORMaTIOn aRE PROVIDED By
ThE EQUIPMEnT ManUFaCTURER anD Can
BE FOUnD In ThE OWnER’s PaCkET.