Toshiba Satellite 31 - Manual (Page 55)

4-2 Hardware User's Manual
Satellite 30DVD/35DVD – S30DVD_UK.doc – ENGLISH – Printed on 16/10/00 as IM_30UK
Connecting a cable to the computer
Please pay attention to the following points, when you make a connection.
If you connect a cable to the computer's port, make sure to attach the
connector the right way up and in the proper direction
If there are fixing screws on the cable's connector, tighten the screw after
the cable has been connected to the computer's port, to prevent it from
getting loose.
Please pay attention to the shape of the connector and attach it properly
when you connect it. If you handle the connector with too much force, pins
could be broken or bent.
When using peripheral devices, there are more procedures necessary
beside the ones mentioned here. These procedures vary according to the
system you are using. For more information please refer to the manuals
that come with each peripheral device.
Exchange selectable devices
The following devices can be installed into the SelectBay.
‰
DVD-ROM drive
‰ Floppy disk drive
Please install the weight-saver into the SelectBay whenever you are not
using it.
For safety reasons please make sure you always have either one of the
selectable modules or the weight-saver installed in the SelectBay.
Please do not swap selectable bay modules under the following
circumstances. Doing so could damage the computer or the selectable
devices and could also result in a data loss.
•
When the computer is turned on
• When the system is in Standby mode
• When the system is in Hibernation mode