Toshiba Satellite 31 - Manual (Page 114)

User's Manual Troubleshooting 8-19
Version
7
Last Saved on 16/10/00 18:34
Satellite 30DVD/35DVD – S30DVD_UK.doc – ENGLISH – Printed on 16/10/00 as IM_30UK
Please set the Dialling Properties and the Modem Properties
when you use a "0" to pre-dial.
Setting the dial properties.
1. Open the Control Panel and double click on Telephony.
The
Dialling Properties
screen appears.
2. Go to Caller Location Info tab, then External Line Number,
and enter 0 (zero) using half-width input mode into either Local Call
or Long-Distance Call, whichever is appropriate, and then click on
the OK button.
3. In the Dialling Properties screen, click on the OK button.
Setting the modem properties.
4. Open the Control Panel and double click on Modem.
The
Modem Properties
screen appears.
5. Select the your modem in the General tab and click on Properties.
6. In the General tab, under Connection Options, uncheck (remove
the mark) the item Wait for dial tone and then connect,
click on the OK button.
7. In the Modem Properties screen, click on the Close button.
If the check box appears in light colour and you cannot select, click on the
Detail Setup
button and enter X3 in Add Setup.
If you click the Detail Setup button in the Connection tab and there is &F
entered in Add Setup, the transmission will not work even if the items
mentioned above are unchecked.
The modem is defect.
If the modem was damaged by lightning, etc., the "No dial tone" error
message appears.
The built in modem does not connect well to a K56flex site
The transmission mode of the built in modem is not suitable. Please follow
the steps below to enable K56flex in the modem's transmission mode.
Sometimes you cannot make a K56flex connection via PBX or through
telephone lines which do not have the NTT quality. In this case, disable the
K56flex and connect with V.34 mode.
1. Open the Control Panel and double click on Modem.
The
Modem Properties
screen appears.
2. Select LT Win Modem and click on Properties.
The
Properties of LT Win Modem
screen appears.