WIKA CPC6000 User Manual
Page 68
Automated Pressure Calibrator
CPC 6000
68
Mensor/WIKA Operating Instructions - CPC 6000
case ‘U’:
/*Units*/
usage “UX”
X = the unit number (ex. U16 = psi)
case ‘V’:
/*Variable_Rate_Mode*/
usage “VXXXXX”
X = the desired control rate setting (ex. V1)
case ‘W’:
/*Wait_Value_Mode*/
usage “WXXX”
X = the desired stable delay setting in seconds (ex. W005 = 5 sec)
Emulated Commands not supported by the CPC 6000:
usage “A”
does nothing
usage “E “
does nothing
usage “O”
Zeroing, software will accept the command but does not
affect the zero status of the instrument
usage “R0”
setting remote to local
usage “R1”
setting to remote
usage “I0”
does nothing
usage “I1”
does nothing
usage “I2”
does nothing
usage “I3”
does nothing
usage “I4”
does nothing
usage “I5”
does nothing
usage “I6”
does nothing
UNITNO 7
(kg/m2) does nothing
UNITNO 10
(mHg) does nothing
UNITNO 17
(lb/ft2) does nothing
UNITNO 21
(Special) does nothing
The Measurement Units below use conversion factors as listed in this manual’s Appendix:
Druck Unitno
Units
Comments
1
Pa
2
kPa
3
mPa
4
mbar
5
bar
6
kg/cm2
7
kg/m2
not supported
8
mmHg
9
cmHg
10
mHg
not supported