WIKA CPC6000 - Manual (Page 57)

Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000 57
118 StableWin {%fs value} Sets the stable window as a %FS.
119 StableWin? {value} Returns the stable window in % of Span.
120 Standby none Instrument placed in Standby mode, all sole-
noids de-energized.
121 Standby? {Yes or No} Returns YES if the active channel is in Standby,
NO if otherwise.
122 Step {value inside upper and
lower limits and inside the
range of the active sensor
and turndown} Sets the control step size for the instrument.
123 Step- {none or value} Jogs the setpoint down one step. If a value is
entered, sets the step size to that value.
124 Step+ {none or value} Jogs the setpoint up one step. If a value is en-
tered, sets the step size to that value.
125 Step? {value} Returns the control step for the instrument.
126 Stop none Stop repeating output over serial port. See:
Repeat
127 Units {units code, or output format
text from Measurement Units
Table 11.1 in the Appendix
Section} Sets the instrument engineering units.
128 Units? {string} Returns the instrument units in a text string.
129 Unlock none Releases Acquire locks. See: Acquire? and
Release?
130 UpperLimit {Value inside primary trans-
ducer range} Sets the upper control limit for the active chan-
nel.
131 UpperLimit? {value} Returns the upper control limit for the active
channel.
132 Vent none Instrument placed in Vent mode.
133 Vent? {Yes or No} Returns YES if active channel is in Vent mode,
No if otherwise.
134 Versions? {string} Returns the versions of the firmware for the
instrument, gpib driver, gate array, installer, and
the graphics library.
135 Volume {value in cc} Sets the system volume in cc’s – only applicable
if the active channel is a low pressure regulator.
136 Volume? {value} Returns the current system volume in cc’s – only
applicable if the active channel is a low pressure
regulator.
137 Zero {desired pressure or ?} Sets active sensor and turndown’s zero to en-
tered pressure, or ? to clear previous value. (See
“Caldisable” command above ref# 19)
138 Zero? {value} Returns zero offset value for active sensor and
turndown.