WIKA CPC6000 - Manual (Page 61)

Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000 61
18 _pcs4 func stby Instrument placed in standby mode in units.
19 _pcs4 func vent Instrument placed in vent mode in units.
20 _pcs4 id? Returns instrument ID.
21 _pcs4 opt? Returns instrument options.
22 _pcs4 outform Sets output format.
23 _pcs4 outform? Returns the current output format.
24 _pcs4 rangemin? Returns the minimum pressure of the active transducer.
25 _pcs4 span? Returns the stored multiplication factor from the active
transducer and turndown.
26 _pcs4 stabledelay 1 to
255 Sets the number of consecutive readings that the pres-
sure must remain within the stable window for a pres-
sure stable indication.
27 _pcs4 stabledelay? Returns the number of readings that must be within the
stable window before a stable pressure is indicated.
28 _pcs4 stablewindow
Sets the pressure window that is used to indicate pres-
sure is stable.
29 _pcs4 stablewindow? Returns the pressure tolerance allowed for a stable pres-
sure indication as a % of span of the active transducer.
30 _pcs4 stat? Returns mode and stable flag status “mode, stable CR
LF”.
31 _pcs4 unit Sets the instrument to specified engineering units.
32 _pcs4 unit? Returns the current engineering units and type of trans-
ducer (A, G, D).
33 _pcs4 xducer? Returns the number of the currently active transducer.
34 _pcs4 zero? Returns the stored zero offset of the active transducer
and turndown in the current pressure units.
7.4.7.2 PCS 200 Emulated Commands and Queries
Table 7.4.7.2 – PCS 200 Emulated Commands and Queries
Command Data Function / Response
CX Control Pressure at last control point and units
C$nnnnnnnX Control Pressure at n in units $
D#X CAL POINT CONTROL MODE NOT SUPPORTED
EX Clear Error/Clear Service Request
E?X Return error code and clear error
F$nnnnnnn1X Re-initialize; $,n ignored
F$nnnnnnn2X RETURN CAL DATA NOT SUPPORTED
F$nnnnnnn3X Return Unit ID string; $,n ignored
F$nnnnnnn5X RETURN QPS TEMPERATURE NOT SUPPORTED