WIKA CPC6000 - Manual (Page 65)

Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000 65
:AUTOvent ON/OFF/1/0 Sets autovent function on or off (automatically vent when
controlling at zero).
:AUTOvent? Returns status of Autovent function.
[SOURCE]
:PRESsure
[:LEVel]
[:IMMediate]
[:AMPLitude] Sets the control pressure.
[:AMPLitude]? Returns current control pressure value.
:SLEW Sets the slew rate in %FS/s.
:SLEW? Returns the current slew value in %FS/s.
:TOLerance
Sets the tolerance for stable indication in %FS.
:TOLerance? Returns the tolerance for stable indication in %FS.
CALCulate
:LIMit
:LOWer
Sets minimum control limit.
:LOWer? Returns minimum control limit.
:UPPer Sets maximum control limit.
:UPPer? Returns maximum control limit.
7.4.7.3.1 Output Formats
1. pressure value
2. pressure, units number, mode
3. pressure, pressure rate
4. pressure, minimum peak, maximum peak
5. pressure, active sensor (P or S) active turndown (1-4)
6. pressure, control point, “stable” or “slewing”
7. pressure, “no barometer” or baro reading
7.4.7.3.2 Error Messages and Error Codes
A recognized command is displayed at the device in the headline with “Remote...”. In case of error
“Remote error...” is displayed. A maximum of 100 errors are stored and can be retrieved successfully.
Table 7.4.7.3.2 - SCPI Command Error Messages and Error Codes
Code Error String Returned
0 No error
-101 Undefined character
-102 Syntax error
-103 Undefined separator
-104 Parameter data type error
-109 Parameter missing
-110 Undefined header
-113 Undefined command
-114 Parameter out of range