WIKA CPC6000 User Manual
Page 25
Automated Pressure Calibrator
CPC 6000
Mensor/WIKA Operating Instructions - CPC 6000
25
5. Installation
5.1 Unpacking the System
In addition to this manual you should have:
CPC 6000 Automated Pressure Calibrator
Power cord
1/8 inch FNPT fitting adapters fastened to rear panel
Any accessories ordered
An envelope containing the Calibration Certificate
Your new instrument was subjected to many hours of functional testing before it left the factory. In
addition to testing, the unit was inspected for appearance prior to being packaged for shipment. Upon
removal from its carton please examine the instrument for shipping damage. Report any apparent
damage to the carrier immediately.
5.2 Dimensions
Figure 5.2 - Dimensions
5.3 Mounting
The instrument can be set up on a table top or it can be rack-mounted. Rack mount adapters are
optional on the CPC 6000 and require an adapter panel (see “
8.2 - Rack Mount Kit
” in Section 8,
Options). The special sensors used in the CPC 6000 are relatively insensitive to tilt and vibration.
However to further assure stability and accuracy, avoid mounting the instrument on surfaces subject
to excessive motor or machinery vibration.
■
■
■
■
■