Kramer Electronics VS-3232DN - Manual (Page 42)

38 VS-3232DN - Using the Configuration Menus
HDMI plus S/PDIF Audio Output Card
Parameter Options/Description Default
36.Reset
SubBoard Re-power: power cycles the port
Factory: performs a factory reset to default values of the port Re-power
151.BLINK ON
AUDIO 1: No video glitch when the audio is connected or
disconnected
0: There is a video glitch when the audio is connected or
disconnected 1
8.2.5 Config Menu—Interface Configuration
This option lets you activate or deactivate the IR (infrared) and Ethernet interfaces.
To activate or deactivate the IR or Ethernet interfaces:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until the following is displayed:
INTERFACE configuration
current:IR-ON Ethernet-ON
The current status of the IR and Ethernet interfaces is displayed.
3. Press ENT to select the Interface Submenu.
4. Select 1 to modify the status of the IR interface or 2 to modify that status of
the Ethernet interface (in this example, 2).
The following is displayed:
Ethernet interface setup
1:make it ACTIVE
2:turn it OFF
5. Press 1 to activate the interface or 2 to deactivate it.
6. Press TAKE to confirm the action.
The interface status is changed. After a few seconds the next option on the
Config Menu is displayed.