Samsung SPH-A503ZKASKE - Manual (Page 9)

Section 1: Getting Started 9
Activating Your Device
Note: As with any other radio-transmitting device, do not touch the antenna while
using your device as this can affect call quality and can cause the device to operate
at a higher power level than is necessary.
3. The device begins searching for a network signal.
4. Once the device finds a signal, the time, date, and day appear in the bottom of the
display.
5. You’re now ready to place and receive calls.
Note: If you are outside of your carrier’s coverage area, the Roaming icon ( ) appears at the top of the device’s
display. If you are outside of your carrier’s coverage or roaming area, the No Service icon ( ) appears at the top of the
device’s display. If you cannot place or receive calls, try later when service is available, or at another location.
Turn Your Device Off
Ⅵ Press and hold the key for two or more seconds. Your device powers off.
Note: If your device is on and you press for less than one second, the device will not power off. This prevents your
device from being turned off accidentally.
Remove the Battery
Important! You must unplug the Travel Adapter (if it is connected) before removing the battery from the device during
charging to avoid damage.
1. Press and hold the key to turn off the device (if on).
2. Push in the battery lock inward (1) and hold it in that
position.
3. Lift the battery away (2), as shown.
Install a Memory Card
1. Open the memory card slot cover on the left side of your device.
2. Slide a memory card (1) into the memory card slot,
with the label side facing up.
Note: Your device is preset to use FAT16-formatted memory cards. If you insert a
FAT32-formatted memory card, the device will ask you to reformat the memory
card. If you do not, you will not be able to access the memory card from the
device. If you do format the memory card, you loose all data you’ve stored on it.
3. Press the memory card into the slot (2) until the card
locks into place.