beautypg.com

User-n – Red Lion PAX2A User Manual

Page 15

background image

15

RESET MINIMUM DISPLAY

When activated (momentary action), rESEt flashes and the Minimum resets

to the present Input Display value. The Minimum function then continues from

that value. This selection functions independent of the selected display.

RESET MAXIMUM AND MINIMUM DISPLAY

When activated (momentary action), rESEt flashes and the Maximum and

Minimum readings are set to the present Input Display value. The Maximum and

Minimum function then continues from that value. This selection functions

independent of the selected display.

DISPLAY SELECT

When activated (momentary action), Line 2 advances

to the next display that is not locked out from the Display

Mode.

ADJUST DISPLAY INTENSITY

When activated (momentary action), the display intensity changes to the next

intensity level.

CHANGE DISPLAY COLOR

When activated (momentary action), Line 1 will change

color.

SELECT PARAMETER LIST

Two lists of input scaling points and setpoint values (including band and

deviation) are available. The two lists are named LISt-A and LISt-b. If a user

input is used to select the list then LISt-A is selected when the user input is not

active and LISt-b is selected when the user input is active (maintained action).

If a front panel key is used to select the list then the list will toggle for each key

press (momentary action). The display will only indicate which list is active

when the list is changed. To program the values for LISt-A and LISt-b, first

complete the programming of all the parameters. Exit programming and switch

to the other list. Re-enter programming and enter the desired values for the input

scaling points, setpoints, band, and deviation if used.

SETPOINT SELECTIONS

The following selections are functional only with a Setpoint plug-in card

installed.

r-1

-

Reset Setpoint 1 (Alarm 1)

r-2

-

Reset Setpoint 2 (Alarm 2)

r-3

-

Reset Setpoint 3 (Alarm 3)

r-4

-

Reset Setpoint 4 (Alarm 4)

r-34

- Reset Setpoint 3 & 4 (Alarm 3 & 4)

r-234

- Reset Setpoint 2, 3 & 4 (Alarm 2, 3 & 4)

r-ALL

- Reset All Setpoints (Alarms 1-4)

PRINT REQUEST

The meter issues a block print through the serial port when activated, and the

serial type is set to rLC. The data transmitted during a print request and the serial

type is programmed in Module 7. If the user input is still active after the

transmission is complete (about 100 msec), an additional transmission occurs.

As long as the user input is held active, continuous transmissions occur.

USEr-n

r-Lo

FNC

Fn

r-Lo

FNC

USEr-n

r-HL

FNC

Fn

r-HL

FNC

USEr-n

dISP

FNC

USEr-n

d-LEU

FNC

Fn

d-LEU

FNC

USEr-n

Color

FNC

USEr-n

LISt

FNC

Fn

LISt

FNC

USEr-n

Print

FNC

Fn

Print

FNC