Vaisala Hydromet Data Collection Platform - Manual (Page 81)

Chapter 4 ____________________________________________ Basic Use of Lizard Setup Software
VAISALA_______________________________________________________________________ 79
Measurements View
In the Measurements view, you can configure measurements for the
sensors you selected and connected in the Equipment and Additional
sensors views; see
Figure 33 on page 79 .
The basic set of sensors is automatically configured. You do not
necessarily need to change the default values for the parameters. You
can skip this view altogether, unless you wish to edit the measurement
names or the validation parameters.
1004-068 Figure 33 Measurements View
Editing Measurement Names
The Select Measurement frame on the upper left of the view displays
a list of the equipment names, signal names, and automatically
generated measurement names. The measurements shown here
correspond to the sensors you have selected in the Equipment and
Additional sensors view. The equipment names and signal names
cannot be changed in this view. The only alteration you can make here
is to change the measurement name to a more descriptive one.