Vaisala Hydromet Data Collection Platform - Manual (Page 71)

Chapter 4 ____________________________________________ Basic Use of Lizard Setup Software
VAISALA_______________________________________________________________________ 69
Common Modem Parameters
All different IP-modem types share the same configuration view:
Device configurations, shown in
Figure 28 on page 69 . This section
describes the parameters for basic use. For advanced modem
configuration, refer to section Configuring TCP/IP-based Telemetry in
Vaisala HydroMet™ Data Collection Platform User’s Guide,
Volume 3.
1004-063 Figure 28 Modem Configuration View
The top of the view shows the parameter set values associated with the
device. The parameter set and the configured component have the same
name. Parameters include station specific and commissioning time
settings, such as PIN codes. For certain modem types, this list may be
empty. Usually there is no need to add or remove parameters, but just to
change the value to an appropriate default value.
NOTE All devices listed above are for IP use only. None of them provides a
traditional, readable ASCII format modem connection. Non-IP
modem controls must be used if ASCII operating mode is required. For
configuration instructions on non-IP modems, refer to Vaisala
HydroMet™ Data Collection Platform User’s Guide, Volume 3,
Configuring Telemetry Options.