Ag Leader EZ-Guide 250 Getting Started Guide - Manual (Page 63)

Set the lightbar port parameters. 1.
Tip − To be able to communicate, the parameters must match those of the device.
Select Next Screen and then press . The Message Selection screen appears. 2.
Set the various message formats to On or Off, depending on whether they are required. 3.
Select Next Screen and then press . 4.
If you turned GGA on, then select the number of decimal places in the GGA message. 5.
Note: Some external devices cannot read the GGA message if there are too many decimal places in the
string.
External Receiver Support
The EZ−Guide 250 lightbar can recieve GPS positions from TSIP−compatible recievers. This enables you to use
any of the correction types available on your receiver, including OmniSTAR, Beacon, and RTK.
The following TSIP−compatible recievers are supported by the EZ−Guide 250 lighbar:
Trimble Case IH Ag Leader New Holland
AgGPS 252 AFS 252 GPS 5100 NH 252
AgGPS 332 − − −
To enable TSIP messages as the correction source:
Connect the receiver to the lightbar and then turn them on. 1.
59