Ag Leader EZ-Guide 250 Getting Started Guide - Manual (Page 53)

The nudge value is displayed on the Tip/Message bar at the bottom of the screen while a nudge icon is
highlighted
•
The first information tab shows the current nudge value. Press the function button.
•
Resetting nudge after each row
You can configure the lightbar to reset the nudged position each time you change rows:
Select Configuration / System / Guidance / Clear Nudge at Swath End. 1.
Select On and then press . 2.
Each time you move from one swath to the next, the nudge value will reset to 0, and the swaths will return to their
original position.
The shift icon
Shift moves the guidance line directly to the vehicle position.
Shift enables you to permanently update the line correction. With the shift and save mode, you can move the line
and save it. This can be useful for higher accuracy work, for example, to offset planting by half a swath width
from one season to the next.
To shift the lines:
Drive the vehicle along the line that you want to map the guidance to. 1.
Note: If you are driving at an angle of more than 10 degrees from the current swath, an error message
appears. You must drive at almost the same angle as the guidance line.
Select the action icon. The Shift to Here screen appears: 2.
49