Ag Leader EZ-Guide 250 Getting Started Guide - Manual (Page 49)

Step 3: Selecting the line to load
Press or one or more times until you select the appropriate line. 1.
Press . The Implement Width screen appears: 2.
Step 4: Setting up the implement
To make optimal use of the EZ−Guide 250 system, correctly configure the implement that is attached to the
vehicle. If the implement is offset and you do not configure it, there will be gaps and overlaps in your coverage.
Press or to adjust the implement width and then press . The Overlap/Skip screen appears. 1.
Note: If you want to eliminate all skips in coverage, you can insert an overlap value to compensate for
GPS errors.
Do one of the following: 2.
If you want your passes to meet so you have full coverage without overlaps, use the default
Overlap/Skip value.
♦
If you want a space between your passes, press to enter a skip distance.
♦
If you want your passes to overlap, press to enter an overlap distance.
♦
Press .The Forward/Back Offset screen appears. 3.
Enter the distance that the implement is offset back from the antenna and then press . The Left/Right
Offset screen appears.
4.
Enter the distance that the implement is offset to the left or right of the antenna and then press . 5.
45