Ag Leader EZ-Guide 250 Getting Started Guide - Manual (Page 20)

Changing the LED Brightness
To adjust the brightness of the LEDs on the lightbar, select Configuration / LED Brightness.
In bright sunlight, increase the brightness to make the LEDs more obvious.
•
In darker conditions, for example driving at dusk, you can lower the brightness settings so the LEDs are
less intense.
•
Getting GPS Corrections
By default, the EZ−Guide 250 lightbar is configured to receive the following free corrections:
REGION CORRECTION
North America WAAS
Europe EGNOS
These corrections provide submeter accuracy with the patch antenna, or 15 cm−20 cm (6 in−8 in) pass−to−pass
accuracy when using the optional Ag15 antenna.
To change the GPS corrections (for example, to configure external GPS), select Configuration / GPS Setup / GPS
Correction Source.
For more information, see Advanced Mode: GPS Corrections.
16