Ag Leader GPS 5100 User Guide - Manual (Page 53)

GPS 5100 Receiver User Guide 4 7
Troubleshooting 5
FlashLoader 200 upgrade utility
Problem Possible solution
The FlashLoader 200 upgrade utility
cannot detect the receiver or
download the firmware. Make sure that:
• Other programs, such as AgRemote and
Microsoft® ActiveSync® technology, are not using
the COM port that the computer is using.
• The receiver is connected to a 12–32 V DC
power source.
• All cables are connected correctly between the
device and the computer.
• The receiver is connected to the correct computer
COM port. To do this:
1. From the FlashLoader 200 menu, select
Settings.
2. Select the check box for a serial link.
3. At Port, select Auto. Click OK.
4. Select the Upload firmware to receiver check
box.
5. Navigate to where the firmware file is saved
and select the file. Click Proceed.
6. From the Auto Port Select dialog, select Use
receiver on port... and click OK.
Once you have checked this, turn off the receiver
then turn it on again. Try again to connect
FlashLoader 200.