Ag Leader GPS 5100 User Guide - Manual (Page 34)

4 Configuring the Receiver
2 8 GPS 5100 Receiver User Guide
4.1
Introduction
Use either the Autopilot interface or the AgRemote utility to change
configuration settings in the GPS 5100 receiver. You will need to
configure the receiver if you connect to a third-party device, for
example.
• If a Trimble AgGPS Autopilot system is configured to use a
GPS 5100 receiver, and the port on the receiver is set to
8-N-1 38.4 K, the Autopilot system automatically configures
the receiver.
• The AgRemote utility is available from the Ag Leader website
(www.agleader.com). This chapter describes how to use the
utility to perform some common configurations.
Note – OmniSTAR VBS and HP are subscriber services that need to be
activated. For more information, see OmniSTAR, page 31.